Search found 6 matches

by nevunx
Mon Jun 12, 2006 7:46 am
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

I have CDClone and CDRWin both of which I was using to try and copy CDGs. CDRWin won't recognise my burner as supporting CDG and CDClone consistently failed to burn the particular disks that I am working on (it works fine for all others that I have tried!) - no matter what it failed with Bad Media e...
by nevunx
Mon Jun 12, 2006 5:22 am
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

I've tried all available burn speeds from slowest to fastest and it makes no difference.

I can see why that would affect the success of the write but not why it would cause the software to hang after successfully writing!
by nevunx
Sun Jun 11, 2006 7:06 pm
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

I have repeated the sequence noted above and it consistently works. The process is as follows: Set the burn settings to CDRDao with mmc-raw disabled. Set write speed. Press copy. Program reads tracks and starts burn process. Burn process fails during writing of Lead-in and generates message advising...
by nevunx
Sun Jun 11, 2006 2:34 pm
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

That fails during the leadin burn and suggests that I change to internal mode. Could it be something to do with the software requesting the drive to open following the burn and, if so, is there anyway to disable that? Edited to Add: Following the CDRAO not working, switching to internal mode, that p...
by nevunx
Sun Jun 11, 2006 2:08 pm
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

I have sent the log file.
by nevunx
Sun Jun 11, 2006 1:28 pm
Forum: Bugs
Topic: Burn Process fails at 99%
Replies: 15
Views: 37610

Burn Process fails at 99%

Hi, I am using a registered version of Power CD+G Burner just downloaded from your site and I have a problem in that the software is hanging when it gets to 99% of the burn process. The disk has actually copied fine but I am unable to close the software or do anything else on the PC unless I reboot ...